[an error occurred while processing this directive]Our Hardware: Universal 8 (U8) and Light 32 (L32)
[an error occurred while processing this directive]The accessory decoders of Multi-Steuerung.de can control electrical and electronic accessory articles:
- [an error occurred while processing this directive]Lighting (light bulbs, LEDs)
- [an error occurred while processing this directive]Magnetic articles (points)
- Servos
- [an error occurred while processing this directive]Motors
- [an error occurred while processing this directive]Faller Car System accessory
- [an error occurred while processing this directive]Smoke generators
[an error occurred while processing this directive]These are mostly stationary accessory articles. But our decoders can also be used as locomotive decoders for conventional/analogue (non-DCC) locomotive operation — with adjustable and reversible voltage.
[an error occurred while processing this directive]The accessory decoders of Multi-Steuerung.de have some common characteristics:
[an error occurred while processing this directive]The 8 (analogue) switching inputs can be switched to ground, can be switched by external switches and even by sensors.
[an error occurred while processing this directive]The DCC input accepts a maximum of 4 DCC addresses with 8 functions each. That is a total of 32 control command from the defined address area for accessory decoders.
[an error occurred while processing this directive]The conventional switching inputs and the DCC inputs can be used at the same time.
[an error occurred while processing this directive]The USB input is used to load the configuration files into the decoder.
[an error occurred while processing this directive]The decoder takes a supply voltage between 5 and 26 V. This voltage is also used for the switched elements on the output side.
[an error occurred while processing this directive]All output drivers can generate PWM, thus allowing for an effective control over intensities (brightness, speed…)
[an error occurred while processing this directive]Each output can switch up to 500 mA, and a single U8 can switch up to 4 Ampere in total (1 Ampere for L32).
[an error occurred while processing this directive]The circuit board of the decoder measures 78 × 63 mm.
[an error occurred while processing this directive]Both decoder variants vary in number and type of output drivers:
[an error occurred while processing this directive]Multi-Steuerung.de Light 32 (L32) |
Multi-Steuerung.de Universal 8 (U8) |
---|---|
[an error occurred while processing this directive]L32 has 32 software BCM output drivers, each with a resolution of 256 steps (8 bits). | [an error occurred while processing this directive]U8 has 8 hardware PWM output drivers, each with a resolution of 256 steps (8 bits). |
[an error occurred while processing this directive]L 32 can control lighting effects with up to 32 lights or light groups. | [an error occurred while processing this directive]U8 can be deployed universally. It can control up to 8 different elements — lights, servos, magnetic articles, smoke generators, motors, Faller Car System accessories … |
[an error occurred while processing this directive]Each output can be switched to ground or high impedance state. | [an error occurred while processing this directive]Each output can be switched to positive power supply, to ground or to high impedance state. |
[an error occurred while processing this directive]The intensity of each output can be controlled by BCM separately. | [an error occurred while processing this directive]The intensity of each output can be controlled by PWM separately. |
– | [an error occurred while processing this directive]Each output can be used to control a servomotor with an adjustable pulse width between 1 and 2 ms. |
– | [an error occurred while processing this directive]Two neighbouring outputs can be connected to build a full bridge. Thus direction-dependant motors and magnets can be controlled. |